3D mixer manufacturers can combine multiple materials into homogeneous mixtures, such as mixing cement, sand, gravel, and water to form wet concrete. They can also increase the contact surface area of materials to facilitate chemical reactions and accelerate physical changes, such as the dissolution and homogenization of granular solutes added to solvents through the mixing machinery. 3D mixer manufacturers also point out that this is a novel material mixer widely used in pharmaceuticals, chemicals, food, light industry, and research institutions. This machine can very uniformly mix powdery or granular materials with good flowability, achieving the desired mixing effect. The centrifugal force during the mixing process causes segregation of materials with different densities.
It is recommended to consider the following when selecting a 3D mixer: Choose a horizontal mixer based on your daily production volume.
Since the processing time for each batch of material is approximately 10 minutes, plus the time for feeding and discharging, the processing time for each batch can be estimated at 15 minutes. Therefore, four batches of material can be processed continuously per hour. For example, if a mixer with a batch capacity of 100 kg is selected, it can process 400 kg per hour. Users can choose a horizontal mixer according to their needs.
The manufacturer of the 3D mixer recommends that relevant personnel perform maintenance during operation to ensure its longevity. The following maintenance suggestions should be followed:
1. Like other machines, the 3D mixer requires frequent use. Use new oil approximately every three months and clean the reducer.
2. Inspect the worm gear, bearings, mechanical seal, worm, etc., 1-2 times per month. The operating parts are flexible; check for loose fasteners and address any abnormalities promptly.
3. If a malfunction is discovered during maintenance, repair it immediately.
4. When disassembling and assembling the 3D mixer, handle it gently and stably to prevent deformation and damage.
5. A crucial and important point is that when not in use, it should be thoroughly cleaned, coated with anti-rust oil, and then covered with a clean covering.
This concludes the introduction to the three-dimensional mixer. As a manufacturer of three-dimensional mixers, we provide our customers with a variety of drying equipment based on our excellent technical experience, comprehensive testing systems, precision processing equipment, and strict management system.